Raw Material, Sampling will be taken based on material batch (1Sample/ Batch) Rev. The container series displayed only represent a sample of the entire fleet. I was creating a SOP document to help our QC personnel understand what is AQL Inspection and how many parts are needed to. We usually make components and also assemblies in batches / lot ranging from 200-50000 parts. Dimensional characteristics, The Quantity shall be min.5 Nos c. least 142 cm2 (22 in2) (ISO 1496/I), whereas the steel-floor containers. Hello everyone, I work in the Medical Device Industry and we use the ANSI/ASQ Z1.4 Standards Inspection Sampling. Visual characteristics, the quantity shall be as per sampling plan. ISO 2859-5 provides a method of establishing sequential sampling plans of discriminatory power essentially equivalent to that of corresponding plans of ISO 2859-1. For New development / ECN Parts: 1) During ISC period, the sampling plan of visual inspection & Dimension will be as double the normal inspection. When three consecutive lots is accepted in tightened inspection changeover to normal inspection. ![]() When one lot in normal inspection is rejected / customer complaint, switchover to tightened inspection. 2.Bought out parts 3.Final / Pre -Dispatch Inspection Parts SAMPLE SIZE FOR VISUAL CHARACTERISTICS (AQL 0,4 II With C=0)ฤก.New Materials / parts inspection will start with normal inspection 2. ![]() SAMPLING PLAN (As per IS 2500, ISO 2859-1 & DIN 40080 ) Sampling plan shall be applicable for 1.Job work Elastomer parts.
0 Comments
Leave a Reply. |